How To Install Omg Led Lights

STEP ane: Alert

• NEVER turn on your LEDs while they are still in the roll. This will crusade them to overheat!
• NEVER connect more strips than the amount included in the gear up you purchased. This can cause your strips to draw more ability than the power supply is manufactured to output and may cause your strips to overheat.

Footstep 2: Pre-Planning your set up

• Be sure to measure out the length of the area yous want to set the lights on
• We recommend having LED lights go vertically up your wall, merely if y'all adopt to start the line horizontal from the height of your wall, you lot will needLED Strip Clipsto help hold up the power supply against the wall.

Footstep three: Preparing a Make clean Surface

• Use a rag or paper towel to clean off whatsoever clay or dust in the expanse y'all'll be applying your LED lights onto. Doing this is absolutely necessary so the agglutinative tin can stick & hold on strongly.

STEP 4: Setting Up Your Lights

• Begin past connecting your LED Controller to the ability supply.

• Last, connect the controller to your lights. Ensure the arrows marshal.

• Peel your adhesive bankroll off the LED strips. Only peel in 8 inch portions to ensure your adhesive doesn't collect dust every bit you are installing your lights. Make sure you lot are peeling merely the adhesive backing from the strip and not pulling the entire adhesive strip off the lights.

Stride 5: Proper Installation

• Start off by applying the kickoff of the strip against the wall gently.
• Attempt staying as close to the corner where the wall and ceiling come across to make certain the lights stay in a straight line when applying them horizontally or vertically.
• Ask a friend or family fellow member to hold the other stop of the lights and skin the plastic a flake at a fourth dimension from the adhesive to help make this process easier.
• NEVER RUN THE LIGHTS FROM THE CONTROLLER, AROUND THE SURFACE, AND BACKINTO THE CONTROLLER. THIS WILL SHORT YOUR LIGHTS.

STEP 6: Turn Power on your Lights

• To properly Connect the Controller Receiver to your LED strip connect matching the 2 arrows
• LED Strip and Controller Receiver both accept arrows at the connection point.

Step seven: Check your remote

• The Remote uses a CR2025 battery.
• Cheque remote by pointing information technology at the Remote Receiver.
• If nothing is happening, merely bank check that the battery was not inserted upside down. Effort flipping it over and check to see if it is now working.

Source: https://omgleds.com/pages/omgleds-1-0-installation-guide

Posted by: cadyfiresom1940.blogspot.com

Share this post